| Precedente :: Successivo |
| Autore |
Messaggio |
malejandrodev
Registrato: 22/08/19 21:21
Messaggi: 1
|
 Inviato: Ven Ago 30, 2019 4:56 am Oggetto: VPN ignores gateway with failure |
 |
|
Hi. I am starting to use Zeroshell and I have a problem. I currently have two tunnels. One for each ISP using the "gateway" parameter. The problem occurs when I disconnect the "ISP 2". The tunnel that goes through the "ISP 2" is connected by the "ISP 1" after a while creating 2 tunnels by the "ISP 1". Apparently VPN ignores the gateway with failure.
I use BOND00 10.0.0.2 using VPN00 and VPN01. Bonding Mode: dynamic balancing.
VPN00 use 192.168.2.1 gateway for make VPN connection via ISP1 (HFC).
VPN01 use 192.168.170.1 gateway for make VPN connection via ISP2 (3G/4G).
 |
|
| Top |
|
 |
wind
Registrato: 01/11/12 09:51
Messaggi: 200
|
| Inviato: Ven Ago 30, 2019 8:29 pm Oggetto: Re: VPN ignores gateway with failure |
|
|
Hi,
in VPN LAN to LAN... for each VPN the gateway must be set to right gateway.
if you leave "AUTO", the firewall will use the GW in UP status.....
Bye!
| malejandrodev ha scritto: | Hi. I am starting to use Zeroshell and I have a problem. I currently have two tunnels. One for each ISP using the "gateway" parameter. The problem occurs when I disconnect the "ISP 2". The tunnel that goes through the "ISP 2" is connected by the "ISP 1" after a while creating 2 tunnels by the "ISP 1". Apparently VPN ignores the gateway with failure.
I use BOND00 10.0.0.2 using VPN00 and VPN01. Bonding Mode: dynamic balancing.
VPN00 use 192.168.2.1 gateway for make VPN connection via ISP1 (HFC).
VPN01 use 192.168.170.1 gateway for make VPN connection via ISP2 (3G/4G).
|
|
|
| Top |
|
|
|
FAQ
Cerca
Gruppi
Registrati
Profilo
Log in
Messaggi privati
